Arduino for STM32

BlackPill F401CC is for boards with 25MHz crystal Generic F401CCUx is for boards with 8MHz crystal You must select "USB support->CDC (generic Serial supersede U(S)ART)" from menu or "Serial" will on serial port (PA9/PA10), not as recognizable USB device. Clipboard01.jpg If you s...

You can try to install this: https://www.st.com/en/development-tools/stsw-link009.html Thanks I downloaded this and installed it. Made no difference I still have no COM port assigned to the STM32 in Device Manager. I should have noted STM32 Cube Programmer is installed. This is with the STLink plug...

You can try to install this: https://www.st.com/en/development-tools/stsw-link009.html Thanks I downloaded this and installed it. Made no difference I still have no COM port assigned to the STM32 in Device Manager. I should have noted STM32 Cube Programmer is installed. This is with the STLink plug...

Maybe I have asked this question in the wrong forum as this is a Windows driver issue not an Arduino IDE issue. I have no problem loading sketches to the STM32 I have loaded the STM32 in Board Manager and it uses the STM32F401CC. I can compile and load sketches to the STM32. The issue is I have is n...

I am in the process of designing an FOC controller for a PMS motor. Using the STM32F401CCU Black Pill. The environment is as follows Windows 7 PC Arduino IDE V 1.8.19 SimpleFOC driver V 2.0.4 I tried uploading pics here but by the time I resized them they were eligible, so I uploaded them in this li...