Page 2 of 2

Re: Bootloader updated to speed up dfu complete to sketch run time

Posted: Fri May 19, 2017 7:13 am
by ag123
i think you have a point there, i realised that there isn't a means to tell if a board is after all a blue pill, we'd need to make do with the present state-of-art - no changes :)

Re: Bootloader updated to speed up dfu complete to sketch run time

Posted: Fri Jun 09, 2017 2:30 am
by vitor_boss
The stm32flash code starts the program after flashes even on DFU mode (BOOT1==1)

https://sourceforge.net/p/stm32flash/co ... ster/tree/

Re: Bootloader updated to speed up dfu complete to sketch run time

Posted: Fri Jun 09, 2017 3:17 am
by RogerClark
vitor_boss wrote:The stm32flash code starts the program after flashes even on DFU mode (BOOT1==1)

https://sourceforge.net/p/stm32flash/co ... ster/tree/
Boot1 should not be set to high when flashing via serial, as on the F103 I think this causes the upload to be put into Flash instead of RAM.

Please read STM's manuals on the STM32 for more details