Hi from Melbourne, Australia

Please read this if you are new to the STM32
User avatar
RogerClark
Posts: 5961
Joined: Mon Apr 27, 2015 10:36 am
Location: Melbourne, Australia
Contact:

Re: Hi from Melbourne, Australia

Post by RogerClark » Sat Nov 12, 2016 9:55 pm

If you install the bootloader with a FT232 or equivalent, then after that you can just plug the board straight into the PC and it will initially show up as a WinUSB DFU device, untill there is a valid sketch.

Then after you have uploaded a sketch, the sketch has the Serial USB in it

Ideally, you need to use a bootloader binary with the LED pin the same as on your board.

Do you know which pin the LED is on?

X71
Posts: 28
Joined: Wed Oct 26, 2016 11:53 pm

Re: Hi from Melbourne, Australia

Post by X71 » Sat Nov 12, 2016 10:48 pm

LED has PC13 printed underneath on the board, so I'm assuming it's pin C13 on the board.
STM32F103VET6-A.PDF
(163.68 KiB) Downloaded 21 times
STM32F103VET6-B.PDF
(164.31 KiB) Downloaded 13 times

User avatar
RogerClark
Posts: 5961
Joined: Mon Apr 27, 2015 10:36 am
Location: Melbourne, Australia
Contact:

Re: Hi from Melbourne, Australia

Post by RogerClark » Sun Nov 13, 2016 12:17 am

If its on PC13 you need the PC13 bootloader

https://raw.githubusercontent.com/roger ... 0_pc13.bin

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest