just a thought, is it safe to use the USB to upload sketches while the board is powered through the VIN pin?
its not sending over voltage up the USB to the computers port and overloading it?
Equally its not in essence doubling the voltage across the dev board?
Also ive not been idling doing nothing.... :p I had a break over Xmas from my project but I got round to building my other led array...
I hope its of some interest.
Post here first, or if you can't find a relevant section!
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest