Using USB while Baite is powered? and some Update on my project

Post here first, or if you can't find a relevant section!
Post Reply
Nutsy
Posts: 224
Joined: Sun Jul 24, 2016 4:26 pm

Using USB while Baite is powered? and some Update on my project

Post by Nutsy » Tue Jan 17, 2017 1:41 pm

just a thought, is it safe to use the USB to upload sketches while the board is powered through the VIN pin?
its not sending over voltage up the USB to the computers port and overloading it?

Equally its not in essence doubling the voltage across the dev board?

Also ive not been idling doing nothing.... :p I had a break over Xmas from my project but I got round to building my other led array...

https://www.youtube.com/watch?v=aUc0ZCumZFc&t

I hope its of some interest.

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests