DreamMaple and FlyMaple

Maple Rev3, Maple Rev 5 and Maple Ret 6, iTead Maple etc
Post Reply
User avatar
FurkanCetin
Posts: 54
Joined: Sat Sep 19, 2015 8:31 pm
Location: Istanbul, TURKEY
Contact:

DreamMaple and FlyMaple

Post by FurkanCetin » Sun Sep 20, 2015 8:34 am

Image
Hi STM32F103 lovers!

Here are some Maple Compatible boards for developing projects:

Discontinued DreamMaple ( Product Link )

Did you see that guy? It's not that bad for STM32 development if you need to use Arduino shields and XBee formed Serial Wireless modules in your project. A month ago DFRobots stopped producing of it. I think STM32 boards still doesn't take enough attention especially by Arduino users. However I see Arduino as a great learning tool while STM32 is needed for one step further projects. You can find this one in DFRobot suppliers if you need.

FlyMaple ( Product Link )

If you are going to integrate 10DOF IMU on your project, why don't you use FlyMaple for prototype. Passing to coding quickly will give you some time. I used to have this board and it's so perfectly designed and produced. Consider it as a development board if you need IMU stuff! (+ there is a demo code available)

User avatar
RogerClark
Posts: 6374
Joined: Mon Apr 27, 2015 10:36 am
Location: Melbourne, Australia
Contact:

Re: DreamMaple and FlyMaple

Post by RogerClark » Fri Sep 25, 2015 9:23 pm

Thanks

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest