A question to the rtos-experienced members here: Is there any practical experience with the following setup?
STMduino w/ FreeRtos --- STlink v2 dongle running Segger's J_link ----- Tracealyzer (Percepio)
Recently Segger is offering a utility which flashes STlink v2 (on board or dongles?) into their J-link (and back) thus you may run Tracealyzer in a streaming mode out of your FreeRtos via the STlink.
http://percepio.com/2016/06/16/st-link- ... streaming/
It seems the above chain may work, but I'm not confident whether the FreeRtos port to 32duino works such it supports the exercise (ie a need for a time_stamping timer - they recommend the 32-bit DWT cycle counter - has to be enabled, etc.)..
PS: It seems the cheapo STlink clones are not supported by the Segger's J-link flashing utility..
Development environment specific, Arduino, Eclipse, VS2013,Em::Blocks etc
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests