stm32G474VET6 Board
Posted: Thu Feb 16, 2023 12:11 pm
I am more hardware related so i build my own G474 board.
No sensors, because i have never used the sensors of the development boards.
The "front" of the pcb is designed to mount it with two bracket at the front plate with USB, LEDs and network accessible.
RTC battery backup.
Connector for the network module (W5500).
4 8bit ports with + and ground connected to a 10 pin header. Each of the others have an additional ground pin. So you need only 1 cable to connect an I/O block (sensors etc).
No sensors, because i have never used the sensors of the development boards.
The "front" of the pcb is designed to mount it with two bracket at the front plate with USB, LEDs and network accessible.
RTC battery backup.
Connector for the network module (W5500).
4 8bit ports with + and ground connected to a 10 pin header. Each of the others have an additional ground pin. So you need only 1 cable to connect an I/O block (sensors etc).
- g474-144.jpg (34.1 KiB) Viewed 4227 times