I would like to port GNSS Arduino Library to STM32 CUBE IDE

Post here first, or if you can't find a relevant section!
Post Reply
demy
Posts: 3
Joined: Wed Mar 06, 2024 8:27 am

I would like to port GNSS Arduino Library to STM32 CUBE IDE

Post by demy »

Dear All,
I would like to port Arudino library into STM32 CUBE IDE. Specifically, there is this library https://www.arduino.cc/reference/en/lib ... o-library/ written for SparkFun's u-blox GNSS GDS RTK2. I need to port example available under below location to STM32 CUBE IDE.

SparkFun_u_blox_GNSS_Arduino_Library-2.2.25\examples\Example13_PVT\Example3_AutoPVTviaUart.

I have no clue where to start.

Could any of you please help me find out a solution ?
Thanks and regards,
User avatar
fpiSTM
Posts: 1738
Joined: Wed Dec 11, 2019 7:11 pm
Answers: 91
Location: Le Mans
Contact:

Re: I would like to port GNSS Arduino Library to STM32 CUBE IDE

Post by fpiSTM »

Simply create your main. Then the copy the setup. And finally the loop in an infinite loop. Copy the bsp files in your project and that all folks.
Post Reply

Return to “General discussion”