hi,i bought a STM32F103RCT6 Developed board.
this board don't have any led or board-key except NRST,
so,which kind of bootloader should i use?
can i use generic_boot20_pc13.bin(as same as blue piils) to download?
and also,when i download the bootloader,i'll change boot0 to pin1,use Demonstrator GUI download generic_boot20_pc13.bin,and reboot,is this right?
thanks!
which bootloader should i use in STM32F103RCT6?
Re: which bootloader should i use in STM32F103RCT6?
you need a
- st-link v2
https://www.adafruit.com/product/2548
https://www.st.com/en/development-tools/st-link-v2.html
https://octopart.com/2548-adafruit+industries-68088022
https://octopart.com/st-link%2Fv2-stmic ... s-20057793
https://octopart.com/st-link%2Fv2-isol- ... s-26029478
or a
- usb-uart dongle that does 3.3v uart
https://sites.google.com/view/makeriot2 ... rduino-ide
https://circuitdigest.com/microcontroll ... g-usb-port
- set boot0
- toggle reset
- flash away
or alternatively get a stm32f401 or stm32f4xx board with usb
stm32f4xx chips has the DFU boot loader built in
https://www.sgbotic.com/index.php?dispa ... page_id=49
- set boot0 (press both boot0 and reset)
- toggle reset (release reset, hold boot0, release boot0 1 s later)
- flash away
with the tools, follow the 'getting started' guide in the wiki
https://github.com/stm32duino/wiki/wiki
- st-link v2
https://www.adafruit.com/product/2548
https://www.st.com/en/development-tools/st-link-v2.html
https://octopart.com/2548-adafruit+industries-68088022
https://octopart.com/st-link%2Fv2-stmic ... s-20057793
https://octopart.com/st-link%2Fv2-isol- ... s-26029478
or a
- usb-uart dongle that does 3.3v uart
https://sites.google.com/view/makeriot2 ... rduino-ide
https://circuitdigest.com/microcontroll ... g-usb-port
- set boot0
- toggle reset
- flash away
or alternatively get a stm32f401 or stm32f4xx board with usb
stm32f4xx chips has the DFU boot loader built in
https://www.sgbotic.com/index.php?dispa ... page_id=49
- set boot0 (press both boot0 and reset)
- toggle reset (release reset, hold boot0, release boot0 1 s later)
- flash away
with the tools, follow the 'getting started' guide in the wiki
https://github.com/stm32duino/wiki/wiki
Re: which bootloader should i use in STM32F103RCT6?
Yes, you need to pull up BOOT0 pin, reset board, use a usb-uart adapter (f103 do not have USB bootloader), flash bootloader.
You can use Demonstrator GUI or STM32QubeProgrammer.
You can use Demonstrator GUI or STM32QubeProgrammer.