Page 1 of 1

[X-NUCLEO] List of libraries

Posted: Tue Nov 28, 2017 12:50 pm
by cparata
Hereafter, an exhaustive list of Arduino libraries to support X-NUCLEO Expansion Boards.
These libraries are guaranteed to work fine with all NUCLEO boards supported in the STM32 Core. They could also work with standard Arduino boards but I suggest to check before electrical and pinout compatibility of X-NUCLEO Expansion Boards with standard Arduino boards.
For more information about the libraries supported in the STM32 Core, you can refer to this link.

X-NUCLEO Expansion Boards
* X-NUCLEO-IKS01A2: it is a motion MEMS and environmental sensor expansion board for the STM32 Nucleo. It depends on the following libraries: * X-NUCLEO-IKS01A1: it is a motion MEMS and environmental sensor expansion board for the STM32 Nucleo. It depends on the following libraries: * X-NUCLEO-53L0A1: it is an expansion board for the STM32 Nucleo based on VL53L0X Time-of-Flight and gesture-detection sensor. It depends on the following libraries: * X-NUCLEO-6180XA1: it is an expansion board for the STM32 Nucleo based on VL6180X proximity sensor, gesture and ambient light sensing (ALS) module. It depends on the following libraries: * X-NUCLEO-IDB05A1: it is a Bluetooth Low Energy evaluation board based on the SPBTLE-RF BlueNRG-MS RF module. It depends on the following library: * X-NUCLEO-IHM02A1: it is a two axis stepper motor driver expansion board based on the L6470 component.
* X-NUCLEO-IKA01A1: it is a multifunctional expansion board based on operational amplifiers.
* X-NUCLEO-LED61A1: it is an expansion board based on the LED6001 component.
* X-NUCLEO-NFC01A1: it is a Dynamic NFC tag evaluation board based on the M24SR64-Y NFC Type 4/RFID tag IC. It depends on the following library: * X-NUCLEO-NFC04A1: it is a dynamic NFC/RFID tag IC expansion board based on the ST25DV04K NFC Type V/RFID tag IC.

Re: [X-NUCLEO] List of libraries

Posted: Tue Nov 28, 2017 9:00 pm
by RogerClark
Thanks for posting.