I try to use connect USB type c with Nucleo F411RE. I connected:
- BOOT0 (red wire) and 5V (yellow wire) to USB C VCC
- GND (black wire) to USB C GND
- DP PA12 (green wire) to USB C DP1
- DM PA11 (blue wire) to USB C DN1
- BOOT1 PB2 (brown wire) to board GND
After I connect to the PC with stm32CubeProgrammer v2.10.0 installed. The red led on the nucleo turns on. But there is no device detected at PC (unlike when I plug in a usb drive it shows find something) and no new device shown in my device manager. And there is "No DFU detected" in stm32CubeProgrammer like: May I know anyone know what wrong with this? Thanks a lot!