hi,
recently i've bought some RCT6 Boards,
i'm trying to write stm32duino in it,but i've meet a strange things;
when i plug the board, system stucked in "STM32duino Bootloader",when i download a firmware, e.g. qmk, and press "reset key",it will function normally,
however,when i reboot the board again, it will stuck at bootloader,not deploly my firmware automatlly,
what should i do? thanks for help!
my STM32F103FCT6 stucked at bootloader,what should i do?
my STM32F103FCT6 stucked at bootloader,what should i do?
check BOOT pins if they are shorted to GND.
Go to full postRe: my STM32F103FCT6 stucked at bootloader,what should i do?
check BOOT pins if they are shorted to GND.
Re: my STM32F103FCT6 stucked at bootloader,what should i do?
Thanks!
turns out,this board did't default connect BOOT0 to GND.
turns out,this board did't default connect BOOT0 to GND.