[SOLVED] Temp sensor DS18B20 on STM32 sometimes read 85

Post here first, or if you can't find a relevant section!
fredbox
Posts: 125
Joined: Thu Dec 19, 2019 3:05 am
Answers: 2

Re: Temp sensor DS18B20 on STM32 sometimes read 85

Post by fredbox »

Assuming the schematic is for a carrier board that holds the blue pill board, I would first power the blue pill separately and just hook up the sensor. If that works, I would hook up the other used pins one at a time until the problem reappears.

I read somewhere that the pins going to the crystals needed to be removed before plugging into another circuit.
mrburnette
Posts: 633
Joined: Thu Dec 19, 2019 1:23 am
Answers: 7

Re: Temp sensor DS18B20 on STM32 sometimes read 85

Post by mrburnette »

Are you "really" supplying +5V from DC-DC to the 3.3V uC as shown in the schematic?
dinihuygens
Posts: 13
Joined: Thu Dec 17, 2020 9:20 am
Answers: 1

Re: Temp sensor DS18B20 on STM32 sometimes read 85

Post by dinihuygens »

mrburnette wrote: Thu Jan 14, 2021 1:34 pm Are you "really" supplying +5V from DC-DC to the 3.3V uC as shown in the schematic?
yeaaa :shock:
dinihuygens
Posts: 13
Joined: Thu Dec 17, 2020 9:20 am
Answers: 1

Re: [SOLVED] Temp sensor DS18B20 on STM32 sometimes read 85

Post by dinihuygens »

thanks all, finally I can overcome this issue by changing the wire cable of my sensor :D
I just cut it off and replace it with the new one
Post Reply

Return to “General discussion”