Error when Using Arduino 1.8.5 - ccplus too many filename
Posted: Sun Jun 20, 2021 2:23 am
In keeping with the FAQs I'll try and not waste your time. I did a search in this forum for ccplus. Nothing came up
I am running Arduino 1.8.5 on Windows 10
I have the STM32 2.0.0. board definitions installed
I am trying to simply compile (nothing more, just the 'verify button), the blink sketch for a generic STM32F1 little blue pill.
I get the following error.
I have removed the IDE and uninstalled the STM32 boards definitions and then reinstalled both. Same error.
I unzipped the IDE to F:\arduino so the path would not have spaces.
I tried a different STM32 board (a Nuecleo F767). Same issue.
I removed mingw32 which had been installed by Choco. Same issue.
Ideas?
I am running Arduino 1.8.5 on Windows 10
I have the STM32 2.0.0. board definitions installed
I am trying to simply compile (nothing more, just the 'verify button), the blink sketch for a generic STM32F1 little blue pill.
I get the following error.
Code: Select all
Alternatives for @C: []cc1plus.exe: error: too many filenames given. Type cc1plus.exe --help for usage
ResolveLibrary(@C)
-> candidates: []cc1plus.exe: fatal error: @C:\Windows\TEMP\ccSG3Lbb: Invalid argument
compilation terminated.
exit status 1
Error compiling for board Generic STM32F7 series.
I unzipped the IDE to F:\arduino so the path would not have spaces.
I tried a different STM32 board (a Nuecleo F767). Same issue.
I removed mingw32 which had been installed by Choco. Same issue.
Ideas?