VL6180x not connecting by I2C to maple mini r2 by Baite
Posted: Sat Oct 16, 2021 10:28 pm
Hi!
I have problem with my maple mini r2 by Baite. I try to use Vl6180x ToF sensor but I can't connect it to my board. I tried both I2C connections on the board (PB6,PB7 and PB10,PB11). I checked if my I2C is working at all and used examples I2C_scanner_wire and I2C_scanner_softwire. Using wire no device can be found and using softwire I get message that mostly all addresses are found. I don't know what to do. Tried to get answers by searching this forum and Roger's GitHub site but no results.
Thanks for your time and all responds.
Regards!
I have problem with my maple mini r2 by Baite. I try to use Vl6180x ToF sensor but I can't connect it to my board. I tried both I2C connections on the board (PB6,PB7 and PB10,PB11). I checked if my I2C is working at all and used examples I2C_scanner_wire and I2C_scanner_softwire. Using wire no device can be found and using softwire I get message that mostly all addresses are found. I don't know what to do. Tried to get answers by searching this forum and Roger's GitHub site but no results.
Thanks for your time and all responds.
Regards!