firmware update
Posted: Mon Nov 14, 2022 6:41 am
hello experts
I have a question about updating the firmware, so I left a question.
I want to proceed with the current firmware update through USART.
I would like to make the BOOT0 pin HIGH only when updating firmware and lower BOOT0 to LOW otherwise.
I don't want to set this as a physical jumper (Like bluepill).
If you have a common method, please give me an idea.
For reference, I use STM32F103RDT6.
I have a question about updating the firmware, so I left a question.
I want to proceed with the current firmware update through USART.
I would like to make the BOOT0 pin HIGH only when updating firmware and lower BOOT0 to LOW otherwise.
I don't want to set this as a physical jumper (Like bluepill).
If you have a common method, please give me an idea.
For reference, I use STM32F103RDT6.