Use more than 10 adc pins F401 BlackPill?
Posted: Fri Jan 27, 2023 5:43 pm
Hi to all,
first of I'm new to STM32. Up to now I have only been working in the classic Arduino realm. The need for more ADC and Hardware PWM pins made me switch to a black pill board.
Is there any way to use more than the standard 10 adc pins (PA0-PB1) on the F401 BlackPill board?
In the documentation it speaks of 16 channels. I would need a total of 12 adc lines for my project.
Any way of defining GPIOs as additional adc pins?
Thx a lot in advance!
Regards,
Mike
first of I'm new to STM32. Up to now I have only been working in the classic Arduino realm. The need for more ADC and Hardware PWM pins made me switch to a black pill board.
Is there any way to use more than the standard 10 adc pins (PA0-PB1) on the F401 BlackPill board?
In the documentation it speaks of 16 channels. I would need a total of 12 adc lines for my project.
Any way of defining GPIOs as additional adc pins?
Thx a lot in advance!
Regards,
Mike