Unable to see any output from serial monitor
Posted: Thu Mar 30, 2023 5:33 am
Good day to everyone here, i am a beginner for nucleo l073rz (connected with I-nucleo-LRWAN1) and for the past 3 days, i have been trying to see my output from my serial monitor, but to no avail, nothings shows up.
These are the codes that i have been trying. If I toggle the builtin led, it works. But if i try to println something, it just does not work.
settings:
board 64
com 15 (exactly my l073rz port)
board part number l073rz
upload method = mass storage
enabled generic serial
Serial monitor baud rate = 115200
I have set the settings as above and still to no avail, i get no Hi from my serial monitor even though the debugging and build are success
Code: Select all
void setup() {
Serial.begin(115200); // Initialize serial communication with a baud rate of 115200
}
void loop() {
Serial.println("Hi"); // Print "Hi" to the serial monitor
delay(1000); // Wait for 1 second
}
settings:
board 64
com 15 (exactly my l073rz port)
board part number l073rz
upload method = mass storage
enabled generic serial
Serial monitor baud rate = 115200
I have set the settings as above and still to no avail, i get no Hi from my serial monitor even though the debugging and build are success